Hi All:
I thought I would pass along some ideas that seem to have worked out (at this point!) with regard to correcting polyurethane flaws in the painting of the BB top deck and also the installation of a rubber seal that I hope will protect the cabin top as I routinely attach and detach the bridge windshield.
As I was seeking advice on how to more efficiently attach the windshield to the boat, Bham-Rick suggested a product called J seal from Wefco. I bought 12' and I think its going to work beautifully for the gasket between the bottom frame of the windshield and the red cabin top. Its fairly thin and the "J" rests right along the bottom of the frame. I am waiting for the glue to cure, then I will drill through and mount the windshield in the normal way with nine bolts into T-nuts.
The other bit of news is how I was able to vastly improve the paint appearance by following your advice. I sanded wet with 1000 grit on a padded block. I used soapy water so I had good lubrication as I sanded. I towel dried the area (shown in the pictures, it is the raised area aft of where the bridge windshield attaches. The area forward of the raised area was NOT done). Then, with a foam bonnet, I applied Perfect-it 2 and the paint just gleamed afterward. To finish I used another 3M product called Finesse-it and used a wool bonnet for this. It is a final polisher product. Fabulous! Many of the flaws disappeared and in its place, the most "wet" looking gloss shine. Its a little hard to appreciate in these pictured but the finish is mirror-like. I also have a shot of the freshly painted Merc 1350. I am very happy (and relieved!!) by this. I will eventually go over the entire boat where it is red with this process.
Best,
Bob
I thought I would pass along some ideas that seem to have worked out (at this point!) with regard to correcting polyurethane flaws in the painting of the BB top deck and also the installation of a rubber seal that I hope will protect the cabin top as I routinely attach and detach the bridge windshield.
As I was seeking advice on how to more efficiently attach the windshield to the boat, Bham-Rick suggested a product called J seal from Wefco. I bought 12' and I think its going to work beautifully for the gasket between the bottom frame of the windshield and the red cabin top. Its fairly thin and the "J" rests right along the bottom of the frame. I am waiting for the glue to cure, then I will drill through and mount the windshield in the normal way with nine bolts into T-nuts.
The other bit of news is how I was able to vastly improve the paint appearance by following your advice. I sanded wet with 1000 grit on a padded block. I used soapy water so I had good lubrication as I sanded. I towel dried the area (shown in the pictures, it is the raised area aft of where the bridge windshield attaches. The area forward of the raised area was NOT done). Then, with a foam bonnet, I applied Perfect-it 2 and the paint just gleamed afterward. To finish I used another 3M product called Finesse-it and used a wool bonnet for this. It is a final polisher product. Fabulous! Many of the flaws disappeared and in its place, the most "wet" looking gloss shine. Its a little hard to appreciate in these pictured but the finish is mirror-like. I also have a shot of the freshly painted Merc 1350. I am very happy (and relieved!!) by this. I will eventually go over the entire boat where it is red with this process.
Best,
Bob
Comment